A lot of drywall damage is within reach of anyone patient with a putty knife. The trouble is that small repairs and big ones can look alike at first, and a patch that is the wrong type for the damage tends to crack, sink or show through the paint within a few weeks. This guide sorts the two.
The homeowner list: repairs that are reasonable to try
Nail pops and screw pops
A small round bump or crack over a fastener means it backed out, usually because the framing shrank as it dried. Drive a new drywall screw a couple of inches above or below it, set the old one below the surface, then cover both with two thin coats of compound. Patching over the pop without re-fastening just hides it until it pushes out again.
Small holes and anchor holes
Anything up to about half an inch takes lightweight spackle, overfilled slightly and sanded flush once dry. Push plastic anchors in below the surface first, or they will show.
A hole up to fist size
A stick-on mesh patch over the hole, then two or three coats of joint compound, each a few inches wider than the last. Thin coats dry better and sand less.
Tools: the short list for small patches
- Two taping knives, 6 and 10 inches wide. The wide one is what makes edges disappear.
- Lightweight spackle for tiny holes and a tub of premixed all-purpose or lightweight joint compound for anything bigger.
- Self-adhesive mesh patches, a few drywall screws and a drill.
- Fine-grit sanding sponge, drop cloth, work light.
- Primer, because bare compound flashes through paint.
Drying time is the part to plan around. The labels assume moderate humidity, and the air on this side of Maui is damp much of the time, with the Kahului Airport station averaging roughly 73 percent relative humidity. Give each coat longer than the tub suggests, and run a fan if the room is closed up.
Warning signs: when the job has outgrown a weekend
These are the points where a repair stops being cosmetic, or where getting it to look right takes skills that are hard to pick up on one wall:
- The board is soft, swollen or stained. Moisture got into the core. Patching over it fails, and the leak behind it needs finding first. See how water-damaged board is replaced.
- The hole is larger than your hand. It needs backing or framing behind it, and a seam that is taped and feathered well enough to vanish.
- It is on the ceiling. Overhead work is harder to keep flat, and a sag or stain usually signals water above.
- The wall has texture. Matching orange peel or knockdown takes practice; a smooth patch on a textured wall is often more visible than the original hole.
- The crack keeps coming back, or angles away from the corner of a door or window. Recurring cracks mean movement, which needs re-taping rather than filler.
- The walls are not drywall. Some older houses have board walls or other panels. Repairs there follow different rules.
Halfway jobs: when a patch is already started
It is fine to stop partway. If you have cut out a damaged piece and then found wet framing, wiring or a hole far bigger than expected, leave the opening clean and send us a photo.
The same applies to an older patch that has failed. If one you made earlier has cracked around its edges or sunk into a shallow dish, the coats probably went on too thick or there was nothing solid behind it. Scrape off anything loose and send a picture; cutting the old patch out and starting again is often simpler than building more compound over it. For larger openings and dented corners, the details are on the page about patching holes of every size, and the rest of our drywall resources cover other repairs.